Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem a bit old but it's eye-catching. It might not be the plushest car in its class and an Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxed and comfortable drive.
We are often asked at Coded Car Keys to replace peugeot key fobs. Whether the problem is ongoing or continuous the following tips will aid.
Water Damage
When you accidentally leave your fob in a puddle or splash it with water during kayaking, swimming, canoeing, rafting, or canyoning, it's most likely to be damaged by water. Keep your key fob in a dry bag whenever you go outdoors or do activities that expose it to a lot of water.
It's also important to make sure the fob has completely dried out before you open it and use it again. If you smell any odors from the fob (such as industrial liquid or windshield washer fluid) This is a further indicator that it is submerged.
A circuit that is wet can cause the battery's power to be depleted or even explode. If you can pull the 308 keyfob from the water you need to turn the button side up and shake as much water out as you can before opening the casing. Take the battery out, and then clean the circuit board with a cotton swab that is dipped in 90 percent alcohol.
Other reasons why your Peugeot 308 remote keyless entry system might be unable to function could be due to a dead coin battery or receiver module issue signal interference, a faulty electronic chip. If none of these are the cause, you can try resetting the system by disconnection of the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start technology which allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the car before entering. This feature is very beneficial particularly during the cold winter months. However, it is possible that the remote start system ceases functioning due to a variety of reasons, like a dead coin battery.
A coin-shaped battery that is in the key fob has a life span of two to four years, depending on how frequently it is utilized and where it was purchased. The date of use is typically written on the package or written in the manual.
If the key fob stops working after exposure to water that is clean then you must take the battery off, clean the electronic chip with a paper towel and isopropyl ethanol, then dry it completely before replacing it. If exposed to soapy or salty water, the chip might be damaged and you'll have to replace the key fob completely.
If you are not sure the battery is in good condition You can test its voltage using an instrument set to the car's voltage range. Connect it to the minus and plus terminals. The voltage should read approximately 12-13 volts however, if it reads lower, the battery must be replaced. You can also try to reset the on-board computer by disconnecting the battery with 12 volts for a short period of time, and reconnecting it in reverse order (positive cable first followed by negative). The engine should now begin.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible the receiver module has developed a fault. It's the part that sends an alarm to the car when your key fob is activated it also acts as an immobiliser. It stops it from starting unless the key that you want to use is present.
The cause could be many factors, including water damage or just aging. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip inside the device will be damaged. In this situation you'll have to take it apart and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try it again.
If the issue persists, it is recommended to consult the local Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the problem and repair it.
Losing your Peugeot keys to your car can be an emotional experience. However, a professional auto locksmith can fix the issue in a matter of minutes. They can cut a new key and programme it to your vehicle, ensuring you can get back on the road again as quickly as possible. Click here to find a locksmith near you.
Faulty electronic chip
The electronic chip that is in the Peugeot 308 key fob is a very important part of the remote control system. If it gets damaged, your car might not start or you may receive a message saying "anti-theft active". In this scenario the only option is to replace the key. Auto locksmiths who are professionals can provide this service in the shortest time.
The chip in your peugeot 306 key replacement;
head to Lovewiki, 308 key fob can become faulty due to water damage, sweat dirt, or other reasons. If your Peugeot key fob has been exposed soapy or dirty water, it should be cleaned promptly. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. After that, let the battery dry completely.
Radio interference can cause the key fob to cease working. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects around the vehicle. It is recommended that you visit a Peugeot dealer in the event of this problem.
The
peugeot 108 key cover 207/308 Key Fob is delicate and needs special care. It is imperative not to throw or drop the key fob. If you lose something, try to find it as soon as you are able to. You can reset the on-board computer by disconnection of the battery for a few minutes. Be sure to disconnect the negative cable first, then the positive.
